FAQs

What is resurfacing?

Resurfacing is a term known throughout the industry, which some people refer to as Refinishing, Reglazing, Restoring or Renewing, the finish on the fixture or fixtures at hand. Where you put a coating over, usually the original surface or previously refinished surface to bring it back to a brand new look of gloss and brightness from when it was first installed.

1


How long do I need to wait before I can use my Tub or Shower after it has been repaired or refinished ?

2

Once it is finished, usually, 24 hours. In some cases, same day.


My Tub or Shower Has a Bad Crack In the Floor, can it be Repaired ?

3

Usually YES,and mostly Yes, Unless there are signs of bad water damage to the structure in the wall, such as the plates or studs or possible mold damage.


This is our only Bathtub/Shower. Can I use it with a crack in the floor if I put Silicone or Caulk in the Crack?

5

If you must use it, You can if you make sure the area around the crack is very dry, by wiping the moisture up with a towel or paper towel, then using alcohol or acetone to evaporate any remaining moisture on the surface and use a blow dryer to make sure it is dry, then use a good duct tape or strong adhesive tape to cover the crack and outside of the crack area with another strip of duct tape on either side. Then take very quick shower only. NO BATHS and try to straddle the area with the crack.

NOTE: If the tape starts lifting up before we can get there, go back to the start above and repeat the process

NO SILICONE CAULK, or CAULKING OF ANY KIND, BONDO, or EPOXY PUTTY.


How can I contact you?

4

You can reach us anytime via our contact page or email. We aim to respond quickly—usually within one business day.